web
You’re offline. This is a read only version of the page.
close
Support Portal

FAQ

What kind of screws are needed to install the optional tether on the DGS35?

Article No: KA-08310
Version: 2.0
Subject to change without notice
Related Products
DGS3x
linear encoders

Table of Contents

There are two american normed screws with the size #10-32 UNC and a thread length of 1/4inch (around 6.25mm) needed to install the tether on the DGS35.
Keywords:
DGS35, tether, screws
Create request