web
You’re offline. This is a read only version of the page.
close
Support Portal

FAQ

TCP/IP commands for the sensingCam SEC100

Article No: KA-10361
Version: 1.0
Subject to change without notice
Related Products
SEC100-5C9D1SFZZZZ SENSINGCAM
SEC110-5C9D1SFZZZZ SENSINGCAM
sensingCam SEC100

Table of Contents

From firmware version 2.1.0 of the sensingCam SEC100 it is possible to execute the following commands via TCP/IP. The SEC100 is the server, whereby the port can be adjusted.


Commands:

STX snapshotTriggerSnapshot ETX Trigger a snapshot
STX eventTriggerEvent ETX Trigger an event recording (SEC110 only)
STX snapshotTriggerNamedSnapshot FILENAME123 ETX Trigger a named snapshot. Change "FILENAME123" accordingly.
STX eventTriggerNamedEvent FILENAME123 ETX Trigger a named event recording (SEC110 only). Change “FILENAME123” accordingly.

 

If the execution was successful, the response is "STX OK ETX".
Keywords:
tcp/ip, command
Create request