web
You’re offline. This is a read only version of the page.
close
Support Portal

FAQ

How to replace a DGS65 with a DFS60?

Article No: KA-08305
Version: 2.0
Subject to change without notice
How to replace a DGS65 with a DFS60?
Related Products
incremental encoders
linear encoders

Table of Contents

The DGS65  is a hollow shaft encoder with a servo flage mounting. The stator coupling is inside of the encoder.

How to replace it usually?

Usually, the easiest way is to use a standard DFS60 with blind hollow shaft to replace this device. Unfortunately, the customer has to drill new holes on the machine.

The replacement type would be the: DFS60x-Bxxxxxxxx

You must ask the customer for the ...

  • needed shaft diameter
  • the output type
  • the electrical connection
  • the needed resolution
Keywords:
replacement, encoder, DGS65, DFS60
Create request