The calibration of the ENS35 / ENM35

Due to the fact, that the ENS35 / ENM35 is a bearing less encoder, the final alignment of the code disc to the sensing unit is made at the mounting of the encoder. Thus, the final calibration must be done on customer site.

The inside of the encoder is shown in the FAQ: KA-10592 -> see the linked FAQ

In the PGT-13-S, we have the possibility to do the calibration with the web GUI.

The following video shows, how this is done:

(the video shows a preliminary version of the PGT-13-S GUI)

Video Link

the calibration can also be done with directly sent commands. Then also the evaluation of the result must be done manualy.

The video below shows how this is done.

Video Link

The attached document shows, how the evaluation is done.

(document will follow)