web
You’re offline. This is a read only version of the page.
close
Support Portal

FAQ

What screw is used for the clamping ring from the ANx58 hollow shaft encoders?

Article No: KA-10224
Version: 1.0
Subject to change without notice
Related Products
ANS/ANM58

Table of Contents

The clamping ring from the ANx58 hollow shaft encoders has a cylinder low head screw with a TORX drive with the norm ISO 14580 TX.

The screw has a M4 thread and a length of 12mm.
Keywords:
ANx58, ANS58, ANM58, hollow shaft encoder, absolute encoder, clamping ring, clamping ring screw
Related Articles
Article
Article Type
Knowledge Topic
Short Description
What tool is needed to tighten the clamping ring screw from the ANx58 hollow shaft encoders and what is the tightening torque?
FAQ
Motion Control Sensors
Create request