web
You’re offline. This is a read only version of the page.
close
Support Portal

FAQ

What needs to be done after having replaced the EOAS sensor in an existing installation?

Article No: KA-09805
Version: 1.0
Subject to change without notice
Related Products
EOAS170T-1A040AZA1 SYSTEM
EOAS170T-P01 PACKAGE
BEF-EOAS-A MOUNTING UNIT
End-of-Arm-Safeguard

Table of Contents

A replacement of the EOAS sensor unit is not problematic. It is possible that the measuring values may differ a little bit due to manufacturing tolerances. Therefore a re-teach of the process points is required. 
Keywords:
Create request