web
You’re offline. This is a read only version of the page.
close
Support Portal

FAQ

How to mount rotary encoders with a blind or through hollow shaft?

Article No: KA-10218
Version: 1.0
Subject to change without notice
Related Products
absolute encoders
incremental encoders
motor feedback systems

Table of Contents
Keywords:
rotary encoders, hollow shaft encoders, blind hollow shaft, through hollow shaft, mounting, different ways
Related Articles
Article
Article Type
Knowledge Topic
Short Description
Is there an overview for the minimum and maximum drive shaft length for all blind hollow shaft encoders?
FAQ
Motion Control Sensors
Is there an overview for the minimum drive shaft length for all through hollow shaft encoders?
FAQ
Motion Control Sensors
Is there an overview for the needed tool to tighten the clamping ring screw from all hollow shaft encoders?
FAQ
Motion Control Sensors
Is there an overview for the tightening torque of the clamping ring screw from all hollow shaft encoders?
FAQ
Motion Control Sensors
What is distinctive for a rotary encoder with a blind hollow shaft?
FAQ
Motion Control Sensors
What is distinctive for a rotary encoder with a through hollow shaft?
FAQ
Motion Control Sensors
What is the recommended tolerance that the drive shaft should has to mount the hollow shaft encoders?
FAQ
Motion Control Sensors
What rotary encoders are available with a blind hollow shaft and with what shaft diameters?
FAQ
Motion Control Sensors
What rotary encoders are available with a with a through hollow shaft and with what shaft diameters?
FAQ
Motion Control Sensors
What screws and washers are needed to mount the standard stator couplings of the hollow shaft encoders?
FAQ
Motion Control Sensors
Create request