web
You’re offline. This is a read only version of the page.
close
Support Portal

FAQ

How to mount rotary encoders with a servo flange using the servo clamps?

Article No: KA-10193
Version: 1.0
Subject to change without notice
Related Products
BEF-WK-SF SERVO CLAMP 3PCS
BEF-WK-RESOL SERVO CLAMP 3ST
BEF-WK-RESOL-L SERVO CLAMP
absolute encoders
incremental encoders
motor feedback systems

Table of Contents

In the following video you will see how to mount a rotary encoder with a servoflange using the servo clamps.

For more information to the encoder groups and the servo clamps, please check out the linked articles.
Keywords:
rotary encoders, solid shaft encoders, servo flange, servo clamps, mounting
Related Articles
Article
Article Type
Knowledge Topic
Short Description
How to mount rotary encoders with a servo-/face mount flange?
FAQ
Motion Control Sensors
What encoder groups are there for encoders with a servo flange regarding the centering and the servo groove width/diameter?
FAQ
Motion Control Sensors
What is distinctive for a rotary encoder with a servo flange?
FAQ
Motion Control Sensors
What screws are needed to mount solid shaft encoders with a servo flange?
FAQ
Motion Control Sensors
Which servo clamps can be used for which encoder? In which pitch circle diameter do the servo clamps have to be mounted?
FAQ
Motion Control Sensors
Create request