web
You’re offline. This is a read only version of the page.
close
Support Portal

FAQ

How to mount rotary encoders with a servo flange using the half shells?

Article No: KA-10195
Version: 1.0
Subject to change without notice
Related Products
BEF-WG-SF050 SERVO CLAMP HALF 2PCS
absolute encoders
incremental encoders
motor feedback systems

Table of Contents

In the following video you will see how to mount a rotary encoder with a servo flange using the half shells.

For more information to the encoder groups and the half shells, please check out the linked articles.
Keywords:
rotary encoders, solid shaft encoders, servo flange, half shells, mounting
Related Articles
Article
Article Type
Knowledge Topic
Short Description
What encoder groups are there for encoders with a servo flange regarding the centering and the servo groove width/diameter?
FAQ
Motion Control Sensors
What is distinctive for a rotary encoder with a servo flange?
FAQ
Motion Control Sensors
What screws are needed to mount solid shaft encoders with a servo flange?
FAQ
Motion Control Sensors
Create request