web
You’re offline. This is a read only version of the page.
close
Support Portal

FAQ

How to mount rotary encoders with a servo flange using the mounting bell?

Article No: KA-10194
Version: 1.0
Subject to change without notice
Related Products
BEF-MG-50 MOUNTING BELL
absolute encoders
incremental encoders
motor feedback systems

Table of Contents

In the following video you will see how to mount a rotary encoder with a servo flange using the mounting bell.

For more information to the encoder groups and the mounting bell, please check out the linked articles.
Keywords:
rotary encoders, solid shaft encoders, servo flange, mounting bell, mounting
Related Articles
Article
Article Type
Knowledge Topic
Short Description
What encoder groups are there for encoders with a servo flange regarding the centering and the servo groove width/diameter?
FAQ
Motion Control Sensors
What is distinctive for a rotary encoder with a servo flange?
FAQ
Motion Control Sensors
What is the maximum length that the shaft stub can be if the mounting bell is fixed directly to the application?
FAQ
Motion Control Sensors
What problems might arise with the mounting bell in relation to the coupling?
FAQ
Motion Control Sensors
What screws are needed to mount solid shaft encoders with a servo flange?
FAQ
Motion Control Sensors
Create request